This paper reviews currently available experimental evidence and predictive techniques for heat transfer and pressure drop during film condensation in horizontal micro-fin tubes, as used in heat pump systems. The enhanced heat transfer mechanism of condensation using micro-fin tubes is explained, and special attention is paid to the dependence of heat transfer and pressure drop on the geometric parameters of the micro-fin tube. It is shown that most of the existing predictive heat transfer and pressure drop models employ strictly empirical techniques. The difficulty of accurate (analytic) modeling of micro-fin tubes lies in the numerous dimensional variables involved in the tube surface, and these are also reported. Heat transfer and pressure drop correlations for micro-fin tubes are presented for pure single fluids and pure mixtures (i.e. R-12, R-125, R-22, R-134a, R-113, R-407C, R-410A, R-32/R-134a, and R-22/R-502/R-134a). The saturation temperatures vary between 22 to 53°C, the mass fluxes between 84 to 910 kg/(m2s), tube diameters between 5.95 to 14.18mm, the number of fins from 24 to 65, fin heights between 0.1 to 0.25mm, apex angles from 25 to 90°, and helix (spiral) angles from 7 to 30°. Correction techniques are suggested when using refrigerant mixtures. It is shown that the currently available correlations satisfy only limited experimental data for a limited number of refrigerants, and that there is little unanimity over a single correlation. The appraisal of the existing correlations by numerous researchers is presented, and recommendations for design calculations are made.

This content is only available via PDF.
You do not currently have access to this content.