Background: Experimental data and a complementary biophysical model are presented to describe the dynamic response of a unicellular microalga to osmotic processes encountered during cryopreservation. Method of Approach: Chlorococcum texanum (C. texanum) were mounted on a cryoperfusion microscope stage and exposed sequentially to various solutions of sucrose and methanol. Transient volumetric excursions were determined by capturing images of cells in real time and utilizing image analysis software to calculate cell volumes. A biophysical model was applied to the data via inverse analysis in order to determine the plasma membrane permeability to water and to methanol. The data were also used to determine the elastic modulus of the cell wall and its effect on cell volume. A three-parameter (hydraulic conductivity solute permeability; (ω), and reflection coefficient, (σ)) membrane transport model was fit to data obtained during methanol perfusion to obtain constitutive property values. These results were compared with the property values obtained for a two coefficient and ω) model. Results: The three-parameter model gave a value for σ not consistent with practical physical interpretation. Thus, the two-coefficient model is the preferred approach for describing simultaneous water and methanol transport. The rate of both water and methanol transport were strongly dependent on temperature over the measured temperature range (25°C to −5°C) and cells were appreciably more permeable to methanol than to water at all measured temperatures. Conclusion: These results may explain in part why methanol is an effective cryoprotective agent for microalgae.
Skip Nav Destination
Article navigation
April 2004
Technical Papers
Measurement and Simulation of Water and Methanol Transport in Algal Cells
John R. Walsh,
John R. Walsh
Department of Biomedical Engineering, The University of Texas at Austin, Austin, TX 78712
Currently at Organ Recovery Systems, Inc. Charleston, SC 29403, U.S.A.
Department of Mechanical Engineering
MCDB-Biology, The University of Texas at Austin, Austin, TX 78712
Search for other works by this author on:
Kenneth R. Diller,
Kenneth R. Diller
Department of Biomedical Engineering, The University of Texas at Austin, Austin, TX 78712
Currently at Organ Recovery Systems, Inc. Charleston, SC 29403, U.S.A.
Department of Mechanical Engineering
MCDB-Biology, The University of Texas at Austin, Austin, TX 78712
Search for other works by this author on:
Jerry J. Brand
Jerry J. Brand
Department of Biomedical Engineering, The University of Texas at Austin, Austin, TX 78712
Currently at Organ Recovery Systems, Inc. Charleston, SC 29403, U.S.A.
Department of Mechanical Engineering
MCDB-Biology, The University of Texas at Austin, Austin, TX 78712
Search for other works by this author on:
John R. Walsh
Department of Biomedical Engineering, The University of Texas at Austin, Austin, TX 78712
Currently at Organ Recovery Systems, Inc. Charleston, SC 29403, U.S.A.
Department of Mechanical Engineering
MCDB-Biology, The University of Texas at Austin, Austin, TX 78712
Kenneth R. Diller
Department of Biomedical Engineering, The University of Texas at Austin, Austin, TX 78712
Currently at Organ Recovery Systems, Inc. Charleston, SC 29403, U.S.A.
Department of Mechanical Engineering
MCDB-Biology, The University of Texas at Austin, Austin, TX 78712
Jerry J. Brand
Department of Biomedical Engineering, The University of Texas at Austin, Austin, TX 78712
Currently at Organ Recovery Systems, Inc. Charleston, SC 29403, U.S.A.
Department of Mechanical Engineering
MCDB-Biology, The University of Texas at Austin, Austin, TX 78712
Contributed by the Bioengineering Division for publication in the JOURNAL OF BIOMECHANICAL ENGINEERING. Manuscript received by the Bioengineering Division September 2, 2003; revision received September 29, 2003. Associate Editor: C. Dong.
J Biomech Eng. Apr 2004, 126(2): 167-179 (13 pages)
Published Online: May 4, 2004
Article history
Received:
September 2, 2003
Revised:
September 29, 2003
Online:
May 4, 2004
Citation
Walsh, J. R., Diller, K. R., and Brand, J. J. (May 4, 2004). "Measurement and Simulation of Water and Methanol Transport in Algal Cells ." ASME. J Biomech Eng. April 2004; 126(2): 167–179. https://doi.org/10.1115/1.1688775
Download citation file:
Get Email Alerts
Cited By
A Novel Port to Facilitate Magnetic Hyperthermia Therapy for Glioma
J Biomech Eng (January 2024)
Evaluation of an Unloading Concept for Knee Osteoarthritis: A Pilot Study in a Small Patient Group
J Biomech Eng (January 2024)
Related Articles
Osmotic Loading of Spherical Gels: A Biomimetic Study of Hindered Transport in the Cell Protoplasm
J Biomech Eng (August,2007)
A Simplified Procedure to Determine the Optimal Rate of Freezing Biological Systems
J Biomech Eng (April,2005)
Synthesis and Characterization of Polyion Complex Membranes Made of Aminated Polyetherimide and Sulfonated Polyethersulfone for Fuel Cell Applications
J. Fuel Cell Sci. Technol (December,2015)
Related Proceedings Papers
Related Chapters
Conclusions
Chitosan and Its Derivatives as Promising Drug Delivery Carriers
An Investigative Study on the Effects of Nano-SiO2 on Compressive Strength and Permeability of Concrete
International Conference on Advanced Computer Theory and Engineering, 5th (ICACTE 2012)
Characterization of Hydrogen Permeability in Zn, Zn-Ni, Cd and Cd-Ti Coated Steel
International Hydrogen Conference (IHC 2012): Hydrogen-Materials Interactions