A computational model of a combined cycle power generation unit is developed and applied to one operated by a local utility company. The objective is to predict the performance of this unit by carrying out energy and exergy analyses of its components. The model is based on thermodynamic, heat transfer, and psychrometric principles, and includes an inlet air conditioning (fogging) system for the gas turbine cycle. To evaluate the model, simulation results are compared with available plant test data at rated load with and without the inlet fogging system in operation.

1.
El-Masri
,
M. A.
,
1985
, “
On Thermodynamics of Gas Turbine Cycles: Part 1—Second Law Analysis of Combined Cycles
,”
ASME J. Eng. Gas Turbines Power
,
107
, pp.
880
889
.
2.
El-Masri
,
M. A.
,
1987
, “
Exergy Analysis of Combined Cycles: Part 1—Air Cooled Brayton Cycle Gas Turbines
,”
ASME J. Eng. Gas Turbines Power
,
109
, pp.
228
235
.
3.
El-Masri
,
M. A.
,
1988
, “
GASCAN: An Interactive Code for Thermal Analysis of Gas Turbine Systems
,”
ASME J. Eng. Gas Turbines Power
,
110
, pp.
201
209
.
4.
Chin
,
W. W.
, and
El-Masri
,
M. A.
,
1987
, “
Exergy Analysis of Combined Cycles: Part 2—Analysis and Optimization of Two-Pressure Steam Bottoming Cycles
,”
ASME J. Eng. Gas Turbines Power
,
109
, pp.
237
243
.
5.
Baughn
,
J. W.
, and
Kerwin
,
R. A.
,
1987
, “
A Comparison of the Predicted and Measured Thermodynamic Performance of a Gas Turbine Cogeneration System
,”
ASME J. Eng. Gas Turbines Power
,
109
, pp.
32
38
.
6.
Bolland
,
O.
,
1991
, “
A Comparative Evaluation of Advanced Combined Cycle Alternatives
,”
ASME J. Eng. Gas Turbines Power
,
113
, pp.
190
197
.
7.
Kehlhofer, R., 1990, Combined-Cycle Gas and Steam Turbine Power Plants, Fairmont Press, Lilburn, GA.
8.
Oh
,
S.-D.
,
Pang
,
H.-S.
,
Kim
,
S.-M.
, and
Kwak
,
H.-Y.
,
1996
, “
Exergy Analysis for a Gas Turbine Cogeneration System
,”
ASME J. Eng. Gas Turbines Power
,
118
, pp.
782
790
.
1.
Hendrickson
,
H. M.
,
1954
, “
How Air Washers Perform When Cooling
,”
Heat./Piping/Air Cond.
, March,
26
, pp.
119
123
;
2.
Hendrickson
,
H. M.
,
1954
, “
How To Calculate Air Washer Performance When Cooling
,”
Heat./Piping/Air Cond.
, September,
26
, pp.
116
121
.
1.
Tisdale, L., and Hauck, R., 2000, “Combustion Turbine Inlet Conditioning—A State of the Art Method of Increasing Generating Capacity Without the Addition of New Basic Generation Hardware,” Paper 2000-GT-192, ASME International Gas Turbine & Aeroengine Congress and Exhibition, Munich, Germany.
2.
Ondryas
,
I. S.
,
Wilson
,
D. A.
,
Kawamoto
,
M.
, and
Haub
,
G. L.
,
1991
, “
Options in Gas Turbine Power Augmentation Using Inlet Air Chilling
,”
ASME J. Eng. Gas Turbines Power
,
113
, pp.
203
211
.
3.
Meher Homji, C. B., and Mee, T. R., 2000, “Inlet Fogging of Gas Turbine Engines; Part A: Theory and Psychrometrics and Fog Generation,” Paper 2000-GT-307 ASME International Gas Turbine & Aeroengine Congress & Exhibition, Munich, Germany.
4.
Japikse, D., and Baines, N. C., 1994, Introduction to Turbomachinery, Concepts ETI, Inc. and Oxford University Press, Norwich, Vermont.
5.
Cohen, H., Rogers, G. F. C., and Saravanamuttoo, H. I. H., 1996, Gas Turbine Theory, Fifth edition, Pearson Education, Harlow, England.
6.
Ganapathy, V., 1991, Waste Heat Boiler Desk Book, Fairmont Press, Lilburn, GA.
7.
Kotas, T. J., 1985, The Exergy Method of Thermal Plant Analysis, Butterworths.
8.
Rivkin, S. L., 1988, Thermodynamic Properties of Gases, Fourth edition, Hemisphere Publishing Corp., Washington, D.C.
9.
Irvine, T. F., 1976, Steam and Air Tables in SI Units, Hemisphere Publishing, Washington, D.C.
You do not currently have access to this content.