An experimental investigation is presented regarding the unsteady pressure field within a high specific speed centrifugal pump impeller (ωs = 1.7) which operated in a double spiral volute. For this, twenty-five piezoresistive pressure transducers were mounted within a single blade passage and sampled in the rotating impeller frame with a telemetry system. The influence of varying volume flux on the pressure transducers was evaluated in terms of pressure fluctuation magnitudes and phase differences. The magnitude information reveals that the pressure fluctuations from the impeller-volute interaction grew as the volume flux became further removed from the best efficiency point and as the trailing edge of the impeller blade was approached. These fluctuations reached 35% of the pump head in deep part load. The upstream influence of the volute steady pressure field dominates the unsteady pressure field within the impeller at all off design load points. Acquired signal phase information permits the identification of the pressure field unsteadiness within the impeller passage as fundamentally synchronized simultaneously with the volute tongue passing frequency. Special emphasis was placed on the volume flux regime where the pump and impeller pressure discharge characteristic undergo hysteresis, as impeller inlet and outlet recirculation commence and cease. A synthesis of the rotating transducers was performed to obtain unsteady blade loading parameters. The value of the unsteady lift coefficient varies on the order of 200% for a single blade in part load operation (at 45% bep), an abrupt fluctuation occurring as the fore running blade suction side passes a volute tongue. The unsteady moment coefficient and center of pressure are also shown to vary significantly during the impeller-volute tongue interaction.

1.
Staubli, T., Holbein, P., and Kaupert, K. A., 1995, “Verification of Computed Flow Fields in a Pump of High Specific Speed,” International Symposium on Numerical Simulations in Turbomachinery, ASME-JSME Fluids Engineering Conference, S.C. Aug. No. FED95–NSTM–AH9.
2.
Brennen, C. E., 1994, Hydrodynamics of Pumps Concepts ETI and Oxford University Press, pp. 196–204.
3.
Makay, E., 1988, “Power Plant Pump Trouble-Shooting State of the Art Overview,” EPRI Report CS-5857, pp. 4.1–4.23.
4.
Tamatsukuri, T., Kikuchi, K., and Satch, J., 1992, “Progress with Ultra High Head Single-Stage Pump-Turbines,” Water Power & Dam Construction, Dec., pp. 29–33.
5.
ISO 1987:5198, International Organization for Standardization, Centrifugal, mixed flow and axial pumps—Code for hydraulic performance test—Precision grade, Edition 1.
6.
Gossweiler, C., 1993, Sonden und Messsystem fu¨r schnelle aerodynamische Stro¨mungsmessungen mit piezoresistiven Druckgebern, ETH Zurich Dissertation #10253.
7.
Kaupert, K. A., 1997, The Unsteady Flow Field in High Specific Speed Radial Pumps, ETH Zurich Dissertation #12068.
8.
Kaupert, K. A., Holbein, P., and Staubli, T., 1996, “A First Analysis of Flow Field Hysteresis in a Centrifugal Impeller,” ASME JOURNAL OF FLUIDS ENGINEERING, Dec. pp. 685–691.
9.
Lorett
J. A.
, and
Gopalakrishnan
S.
,
1986
, “
Interaction Between Impeller and Volute of Pumps at Off-Design Conditions
,”
ASME JOURNAL OF FLUIDS ENGINEERING
, Vol.
108
, pp.
12
18
.
10.
Adkins
D. R.
, and
Brennen
C. E.
,
1988
, “
Analyses of Hydrodynamic Radial Forces on Centrifugal Pump Impellers
,”
ASME JOURNAL OF FLUIDS ENGINEERING
, Vol.
110
, pp.
20
28
.
11.
Wesche, W., 1987, Messungen am Spiralgeha¨use einer Kreiselpumpe, Technische Rundschau Sulzer 2/87, pp. 17–20.
12.
Arndt, N. K. E., 1988, Experimental Investigation of Rotor-Stator Interaction in Diffuser Pumps, Dissertation California Institute of Technology, Engineering and Applied Science.
13.
Tourret, J., Kamga, M., Foucher, D., and Kermarec, J., 1989, “Hydraulic Noise Studies from a Centrifugal Pump Through Pressure Pulsations Measurements in the Volute and in the Impeller,” Societe Hydrotechnique de France, XXe Journees de l’Hydraulique, Lyon 4–6 April, Report No. 8.
This content is only available via PDF.
You do not currently have access to this content.