An analytical solution is presented for the static deformation and steady-state vibration of simply supported hybrid cylindrical shells consisting of fiber-reinforced layers with embedded piezoelectric shear sensors and actuators. The piezoelectric shear actuator, which is poled in the circumferential direction, will induce transverse shear deformation of the hybrid shell when it is subjected to an electric field in the radial direction. Suitable displacement and electric potential functions that identically satisfy the boundary conditions at the simply supported edges are used to reduce the governing equations of static deformation and steady-state vibrations of the hybrid laminate to a set of coupled ordinary differential equations in the radial coordinate, which are solved by employing the Frobenius method. Natural frequencies, mode shapes, displacements, electric potential, and stresses are presented for four-layer hybrid laminates consisting of a piezoelectric shear sensor and actuator sandwiched between fiber-reinforced composite layers. Active vibration damping is implemented using a positive position feedback controller. Frequency response curves for different controller frequencies, controller damping ratio, and feedback gain demonstrate that the embedded shear actuator can be used for active damping of the fundamental flexural mode. In addition, it is demonstrated that vibration suppression of thickness modes is also feasible using the piezoelectric shear actuator.
Skip Nav Destination
Article navigation
August 2005
Technical Papers
Analysis of Static Deformation, Vibration and Active Damping of Cylindrical Composite Shells with Piezoelectric Shear Actuators
Senthil S. Vel,
Senthil S. Vel
Assistant Professor
Department of Mechanical Engineering
Search for other works by this author on:
Brian P. Baillargeon
Brian P. Baillargeon
Graduate Student
Department of Mechanical Engineering
, University of Maine, Orono, Maine 04469
Search for other works by this author on:
Senthil S. Vel
Assistant Professor
Department of Mechanical Engineering
Brian P. Baillargeon
Graduate Student
Department of Mechanical Engineering
, University of Maine, Orono, Maine 04469J. Vib. Acoust. Aug 2005, 127(4): 395-407 (13 pages)
Published Online: August 5, 2004
Article history
Received:
August 26, 2003
Revised:
August 5, 2004
Citation
Vel, S. S., and Baillargeon, B. P. (August 5, 2004). "Analysis of Static Deformation, Vibration and Active Damping of Cylindrical Composite Shells with Piezoelectric Shear Actuators." ASME. J. Vib. Acoust. August 2005; 127(4): 395–407. https://doi.org/10.1115/1.1898337
Download citation file:
Get Email Alerts
Related Articles
Active Damping of Nonlinear Vibrations of Functionally Graded Laminated Composite Plates using Vertically/Obliquely Reinforced 1-3 Piezoelectric Composite
J. Vib. Acoust (April,2012)
Vibration Suppression in Cutting Tools Using a Collocated Piezoelectric Sensor/Actuator With an Adaptive Control Algorithm
J. Vib. Acoust (October,2010)
Hybrid Damping Through Intelligent Constrained Layer Treatments
J. Vib. Acoust (July,1994)
Nonlinear Forced Vibrations of Laminated Piezoelectric Plates
J. Vib. Acoust (April,2010)
Related Proceedings Papers
Related Chapters
Fault-Tolerant Control of Sensors and Actuators Applied to Wind Energy Systems
Electrical and Mechanical Fault Diagnosis in Wind Energy Conversion Systems
Key Technology of Interactive Music Game Installation based on Arduino
International Conference on Control Engineering and Mechanical Design (CEMD 2017)
Fiber-Reinforced Plastic Pressure Vessels and ASME RTP-1–Reinforced Thermoset Plastic Corrosion-Resistance Equipment
Online Companion Guide to the ASME Boiler & Pressure Vessel Codes